Repair Instructions
7.13
Assembling the intake system
1
Assemble the carburetor flange on the intake
bellows. Fit the impulse hose, intake bellows and
partition wall on the cylinder. See figure 26.
2
Place a new cylinder pedestal gasket on the cylin-
der. See figure 26b.
3
Fit the cylinder. The screws (4x) must be tightened
crosswise with a tightening torque of 13-15 Nm.
4
Fig 26
Fit the handle system and hand guard.
5
Fit the carburetor, the filter holder and the air filter
as outlined in "Assembling the carburetor".
Fig 26b
34 –
English