Table of Contents
Advertisement
NB (for models with on board unit): appliances with unit on
board must be handled in the upright position.
If the equipment is handled in a horizontal position, make sure
to wait a few hours before operating it. This is to give the oil time
to settle.
CAUTION:
Do not push or pull the appliance to move it, as it may tip over.
B.1.2.2 Disposing of the packaging
Packaging materials should be disposed of in accordance to
the binding laws in the country where the appliance is to be used.
Recyclable plastic parts are marked as follows:
polythene: outer wrapping, instructions booklet bag
PE
polypropylene: straps
PP
polystyrene foam: corner pads
PS
B.1.3 POSITIONING
Install the equipment, taking all the safety precautions
required for this type of operation, also respecting the
relevant fire-prevention instructions.
Place the appliance in a ventilated room and away from
heat sources such as radiators or air-conditioning
systems, in order to allow the cooling of the refrigerating
unit components.
Never cover the condenser, not even temporarily, as
this may jeopardise the operation of both the condenser and the
appliance.
Should the appliance be installed in rooms where there are
corrosive substances (chlorine, etc.), it is advisable to wipe over
all the stainless steel surfaces with a cloth coated with vaseline
oil to create a protective film.
The room temperature should not exceed 89.6°F/+32°C in order
to maintain the recommended internal temperatures. Make
sure to position the appliance at least 1.97"/50mm from any
machines present in the room (in fact, close proximity can create
problems of condensation forming on the walls of the appliance),
also taking into consideration the space needed for door opening.
Pay particular attention to levelling of the floor on which the
appliance stands, in order to ensure its optimal operation.
IMPORTANT:
Level the appliance, otherwise its operation could be com-
promised.
Adjust the height and level the appliance by means of the
leveling feet, checking that the door opens and closes properly.
+50 mm
+ 1.97 "
B.1.3.1 Installation of the condensation tray (see pict. 1- 5)
14
-10 mm
- 0.39 "
1
2
Advertisement
Table of Contents
