Table of Contents
Advertisement
HOW TO USE
PACKAGING AND POSITIONING
Food must be frozen before placing into the freezer.
Food must be packed in airtight and moisture-proof
packaging to pevent it from drying out.
Never fill the freezer above the „load line" mark (see on
the figure) which can be found on the innerside of the
appliance.
TEMPERATURE CONTROL
The thermostat ensures that the required temperature is
maintained in the freezer. Adjust the temperature by turning
the button with a coin that fits the groove. Turning the
thermostat button towards no. 7 makes the temperature in
the freezer colder, and turning the button towards no. 1
makes the temperature warmer.
The correct setting can be found by measuring the
temperature of the top package in the middle of the freezer.
This should not have a temperature higher than -18°C.
The thermostat has been adjusted to the optimal position by
the manufacturer. Please do not adjust the thermostat
unless the temperature is permanently higher than -18 °C.
IMPORTANT
1. Before adjusting the temperature please
disconnect the appliance from the electricity
supply and remove the plastic grid from the right
side of the freezer.
2. Adjust the required temperature.
3. Fit the plastic grid to the appliance.
4. Reconnect the freezer to the electricity.
It is possible that the compressor does not start
immediately after a short-time disconnection from
the electricity supply.
WARNING
Before fitting the plastic grid to the freezer you must
not reconnect the appliance to the electricity.
LOCK
(Not a standard accessory for all models.) The freezer can
only be locked when the upper lid is pushed to the left and
the lower lid is pushed to the right. Insert the key in the lock
and turn. The key can be removed. Remember to keep the
key out of the reach of children.
BASKET
(Not a standard accessory for all models.) The baskets are
designed for the storage of food which has already been
frozen. The baskets can be hung on the edge of the frame.
GB
5
Advertisement
Table of Contents
