To Lock The Leg; Stabilization Of Vehicles - Idex Vetter QuickStrut Operating Instructions Manual

QuickStrut Page: 13

TO LOCK THE LEG

6
To lock the extended leg, use one of the
hand tools thru the locking shaft / eccentric
shaft of the strut. Turn until it is secure (6).
STABILIZING A VEHICLE
STEP ONE
Extend leg to desired position. Place
QuickStrut against the vehicle. If necessary,
take measures to secure the base plates
from slipping. Make sure the extended leg
is locked in position. Loosen strap enough
to reach a hook in point at the bottom of
the by use of strap and strut established
triangle.
STEP TWO
Once the third side of the triangle is hooked
in and secure, roll up the extra strap using
the hand crank of the strap keeper. When
all of the slack has been taken up, use the
ratchet mechanism to tighten and secure
the stabilization strut in position.
Repeat Step Two for the second QuickStrut.
NOTE: QuickStrut can be deployed with the extending leg either up or down.
**Secure the stabilized/supported load before taking down the rescue strut!**
**Take down is accomplished by releasing the eccentric shaft **