Application Instructions; To Loosen Tension Strap; To Tighten Tension Strap; To Extend The Quickstrut - Idex Vetter QuickStrut Operating Instructions Manual

QuickStrut Page: 12
APPLICATION INSTRUCTION

TO LOOSEN TENSION STRAP

Bring ratchet handle up and pull tab toward
top of handle (1). Hold tab and continue
to fold handle into the shown direction (2)
until it has cleared the ratchet teeth and can
be locked into place on the backside. Pull
strap to get the desired amount of slack. For
quicker deployment pull strap housing away
from strut (3) and pull the strap.
3

TO TIGHTEN TENSION STRAP

4
After all of the extra strap is rolled back
up with the hand crank use the ratchet
handle to tighten the tension strap as necessary
by up-and-down movements (4).

TO EXTEND THE QuickStrut

Press handle directed to the strut (5).
5
Leg should move freely. Once it is in
the desired position release the handle.

TO MAKE INCREMENTAL ADJUSTMENTS

The shaft on the side of the handle can be
turned with a hand tool to make incremental
adjustments to the extended leg.
NOTE: Do not use this feature for lifting or spreading.