12.9
Disposal
Do not dispose the machine, machine components fuel and oil in residual waste. Contact your local
authorities for information regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
13
TROUBLE SHOOTING
Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with interruptions
Oil alarm indicator light flashes
Oil alarm indicator light glows
Output indicator light interval flash 1x
Output indicator light interval flash 2x
Output indicator light interval flash 3x
Output indicator light interval flash 4x
Should you in necessary repairs not able to properly to perform or you have not the
prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-STE1100IV
Possible cause
Incorrect starting sequence
Dirty air cleaner
No fuel supply
Fault in the fuel line
Engine flooded.
Spark plug connector not placed on.
No ignition spark
Fuel cock closed
Engine oil to few
Incorrect idle adjustment
Carburetor incorrectly adjusted
Spark plug fouled
Check oil level
To less or no oil
Low voltage protection activated
High temperature protection activated
Overload protection activated
Short circuit protection activated
N O T I C E
Solution
Observe the correct starting
sequence
Clean/replace air cleaner
Refuel
Check the fuel line for kinks or
damages
Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times and
reinstall the spark plug
Place on the spark plug
connector
Clean/replace spark plug
Check ignition cable
Open fuel cock
Check engine oil
Contact customer service
Contact customer service
Clean/replace spark plug
Check spark plug connector
Fill engine oil
Fill engine oil
Engine speed to low
Cool down the engine
To big loads
Check loads
29