Cleaning And Sanitizing - XpressFill XF4400 Manual

XPRESSFILL Systems LLC | 6
4
Cleaning & Sanitizing
Cleaning the liquid flow path
is to first clean the liquid flow path. Connect the hose to your cleaning/sanitizing solution in a
pressurized container. Place an empty can under each of your spouts and activate the fill switch.
As the cans become full, turn off the switch and empty the cans. Repeat this operation server al
times until you feel the flow path has been sufficiently cleaned.
Cleaning the CO2 flow path
is to first clean the CO2 flow path. Connect the hose to your cleaning/sanitizing solution in a
pressurized container. Place an empty can under each of your spouts and activate the fill switch.
As the cans become full, turn off the switch and empty the cans. Repeat this operation server al
times until you feel the flow path has been sufficiently cleaned.
After you have finished the cleaning cycles above, you may further flush your machine with air
or CO2 to dry it out. Just hook up as pictured and run the cycles as described above.