Cisco CSA 90 Series Installation And Maintenance Manual page 24

Install Cisco x90 Series Content Security Appliances In a Rack
Figure 1-4
1
2
Figure 1-5
1
2
(Optional) Secure the appliance in the rack more permanently by using the two screws that are provided
Step 5
with the slide rails. Perform this step if you plan to move the rack with appliances installed.
With the appliance fully pushed into the slide rails, open a hinged slam latch lever on the front of the
appliance and insert the screw through the hole that is under the lever. The screw threads into the static
part of the rail on the rack post and prevents the appliance from being pulled out. Repeat for the opposite
slam latch.
Install the Cable Management Arm (Optional)
Note
With the appliance pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from
Step 1
the appliance onto the end of the stationary slide rail that is attached to the rack post (see
Slide the tab over the end of the rail until it clicks and locks.
Step 2 Slide the CMA tab that is closest to the appliance over the end of the inner rail that is attached to the
appliance (see
Step 3 Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the
width of your rack (see
Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide
Step 4
rail that is attached to the rack post (see
and locks.
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
1-10
Inner Rail Release Clip for 1-RU Appliances
1
Inner rail release clip
Inner rail attached to appliance and inserted
into outer rail
Inner Rail Release Clip for 2-RU Appliances
1
Inner rail release clip
Inner rail attached to appliance
The Cable Management Arm (CMA) is reversible left to right. To reverse the CMA, see
the Cable Management Arm (Optional), page 1-11
Figure 1-6). Slide the tab over the end of the rail until it clicks and locks.
Figure
Chapter 1
2
3 Outer rail attached to rack post
2
3
Outer rail attached to rack post
1-6).
Figure 1-6). Slide the tab over the end of the rail until it clicks
Install Cisco x90 Series Content Security Appliances
3
3
before installation.
Reverse
Figure 1-6).