Chapter 4
Cisco C690 Email Security Appliance
Table 4-1
Front Panel LEDs, Definitions of States
LED Name
1
Hard drive fault
2
Hard drive activity
3
Power button/LED
4
Unit identification
5
System status
6
Fan status
7
Temperature status
State
•
Off—The hard drive is operating properly.
•
Amber—Drive fault detected.
•
Amber, flashing—The device is rebuilding.
Amber, flashing with one-second interval—Drive locate function activated.
•
Off—There is no hard drive in the hard drive tray (no access, no fault).
•
Green—The hard drive is ready.
•
Green, flashing—The hard drive is reading or writing data.
•
Off—There is no AC power to the appliance.
•
Amber—The appliance is in standby power mode. Power is supplied only to the
•
Baseboard Management Controller (BMC) and some motherboard functions
which enable you to use remote power commands.
Green—The appliance is in main power mode. Power is supplied to all appliance
•
components.
Off—The unit identification function is not in use.
•
Blue—The unit identification function is activated.
•
•
Green—The appliance is running in a normal operating condition.
•
Green, flashing—The appliance is performing system initialization and memory
check.
•
Amber—The appliance is in a degraded operational state. For example:
–
Power supply redundancy is lost.
–
CPUs are mismatched.
–
At least one CPU is faulty.
At least one DIMM is faulty.
–
At least one drive in a RAID configuration failed.
–
Amber, flashing—The appliance is in a critical fault state. For example:
•
Boot failed.
–
Fatal CPU and/or bus error is detected.
–
The appliance is in an over-temperature condition.
–
•
Green—All fan modules are operating properly.
•
Amber—One or more fan modules breached the critical threshold.
•
Amber, flashing—One or more fan modules breached the non-recoverable
threshold.
•
Green—The appliance is operating at normal temperature.
Amber—One or more temperature sensors breached the critical threshold.
•
Amber, flashing—One or more temperature sensors breached the
•
non-recoverable threshold.
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Status LEDs and Buttons for Maintenance
4-5