9.3 Power supply
WARNING Electrocution
Carry out all electrical connection and installation
work in accordance with relevant regulations.
WARNING Electrocution
When permanently connected to the power supply
using a dedicated junction box, the appliance must
be able to be isolated from the mains power supply
by an isolator that disconnects all poles with at least
3 mm contact separation.
WARNING Electrocution
Ensure that the appliance is earthed.
Material losses
!
The voltage specified on the type plate must match
the mains voltage.
» Observe the type plate.
The following electrical connections are permissible:
Connection to a freely acces-
sible standard socket with
matching plug
Permanent connection to an
appliance junction box with
earth conductor
10. Commissioning
WARNING Electrocution
Commissioning may only be carried out by a qual-
ified contractor in accordance with safety regula-
tions.
10.1 Initial start-up
1.
» Either open the DHW valve of the tap or set the
mono lever mixer tap to "hot" until the water that
flows out is free of air bubbles.
» Insert the plug into the standard socket or set the
fuse/MCB in the fuse box.
» Select a temperature.
» Check the entire hydraulic installation for tightness.
Note
If you fail to follow the correct sequence (first water,
then power), the high limit safety cut-out will trip.
Proceed as follows:
» Disconnect the appliance from the power sup-
ply.
» Fill the appliance with water.
» Connect the appliance to the power supply.
10.1.1 Appliance handover
» Explain the functions of the appliance to the user.
Show the user how to operate the appliance.
» Make the user aware of potential dangers, especially
the risk of scalding.
» Hand over these instructions and, if applicable, the
instructions for any accessories.
Huz 5 ÖKO Comfort Hoz 5 Comfort
X
X
2.
Installation – for qualified contractors
10.2 Recommissioning
See chapter "Installation / Commissioning / Initial start-
up".
11. Settings
11.1 Setting the temperature limit
1 Limiting ring
2 Temperature selector
Placing the limiting ring behind the temperature selector
allows you to limit the setting range of the temperature
X
selector to a specific maximum temperature.
» Turn the temperature selector to zero (fully an-
X
ti-clockwise to "•").
» Pull off the temperature selector and the limiting ring.
» Push the limiting ring with the required maximum set-
ting onto the controller shaft.
» Install the temperature selector set to zero (•
12. Shutdown
» Isolate the appliance from the power supply by
removing the plug or by tripping the MCB in the fuse
box.
» Drain the appliance (see chapter "Installation / Main-
tenance / Draining the appliance").
13. Troubleshooting
Fault
Cause
The appliance
The high limit
does not supply
safety cut-out has
hot water.
tripped.
Loud boiling
The appliance is
noises inside the
scaled up.
appliance.
1
2
).
Remedy
Remedy the cause of the fault.
If necessary, replace the tem-
perature controller. Allow the
appliance to cool down. If you
have isolated the appliance
from the power supply, the
high limit safety cut-out will be
reset automatically.
Descale the appliance.
17