Installer Parameters - Computime Salus Controls VS30W Full User Manual

6. Installer parameters

To enter installer parameters please follow steps below. Please refer to parameters table description before any changes. Use
up or down between all parameters. Every change/selection confirm by
1
Hold
+
seconds to enter the installer mode.
3
Press
dXX Function
Control method
d01
temperature
d02 Offset temperature
Using a floor temperature
d03
sensor (S1, S2)
External sensor
used for air
or floor temperature
d04
measurement
(Function is active,
when d03=1)
buttons for 5
+
button to confirm.
Parameter
Values
This parameter defines the algorithm of the room temperature control.
0
1
2
-3.0°C to
+ 3.0°C
0
1
0
1
button:
2
Use
4
Select installer parameter by or
buttons. Use
change parameter value.
Confirm choice by
PWM (Pulse-width modulation) algorithm ensures reduction of overdrive
states and economic operation of the system. It is an advanced algorithm
designed to precisely maintain room temperature.
SPAN ± 0.5°C (± 1°F)
SPAN ± 1°C (± 1.5°F)
Offset room temperature measuring is a function which allows user to
recalibrate internal thermostat's temperature sensor by a given number of
degrees (in the range from -3,0 °C to 3,0 °C in 0,5°C steps).
Sensor is connected
Thermostat measures the temperature only on the
external sensor
The sensor is used as a protection against
overheating the floor
or to choose
code „49".
3
or buttons to
button.
Description
No sensor
or buttons to move
Default
Values
0
0.0°C
0
0
25