Table of Contents
Advertisement
Getting Started
2. Getting Started
2.1 Turning Reader On and Off
The reader can be powered on by any of the following methods:
Pressing and holding the OK button for 1 second.
•
Connecting the reader to the included AC power supply or USB port of a PC.
•
Upon powering up, the reader will display a splash screen and emit a short beep. This screen will
display the present firmware version in the bottom right corner. After approximately 1.5 seconds,
the reader will display the main screen.
Screen during power up
Note: Operating ambient temperature of the HPR Lite reader must be between -20°C (-4°F) and
+58°C (+136.4°F) with relative humidity between 10% and 90%, non-condensing.
The reader can be powered off by any of the following methods:
•
Pressing and holding the OK button while in main screen. After approximately one second
a shutdown timer will appear. Continue holding the OK button until the reader sounds two
beeps and shuts down. The countdown can be aborted by releasing the OK button.
The reader will automatically power off after a certain period of inactivity. The inactivity
•
time is user adjustable and by default is set to 180 seconds (3 minutes). Pressing any
button will reset the timer.
The reader will stay powered on while:
The reader is connected to the AC power supply or USB port of a PC.
•
The reader is connected to a PC via Bluetooth in slave mode (remote device has
•
established the connection). The reader will power off automatically after 60 minutes of
inactivity.
HPR Lite Reader User Manual
V1.07.00
07/21/2020
READY
SHUTDOWN...
3
Press and hold READ to
scan
MEMORY
00000
07/21/2020
READY
Press and hold READ to
scan
MEMORY
00000
Main Screen
3:13 PM
3:13 PM
7
Advertisement
Table of Contents
