Connect Filled Lp Tank - Weber 3400 LP Instructions Manual

Check that the tank panel tabs are in their slots in the
frame brace. Figure 18.
Figure 18
Check that all the burner valves are off.
Valves are shipped in the OFF position, but you should
check to be sure. Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn,
they are off. Proceed to the next step. Figure 19.
Figure 19
Step 13

Connect filled LP tank

WARNING: Make sure that the LP tank valve is
closed. Close by turning clockwise.
Hook the LP tank onto the fuel scale. Loosen the tank
lock wing nut. Swing the tank lock down. Tighten the
wing nut. Figure 20.
Figure 20
Tank panel tabs
Tank lock wing
nut
9
Remove the tape from the hose and regulator.
Route the hose so it will not interfere with the scale
indicator rod.
The hose and regulator are connected in the
following manner:
Slide back the collar of the quick disconnect on the tank
valve. Push the male fitting of the regulator into the quick
disconnect, and maintain pressure. Slide the collar
closed. Figure 21 (a). Figure 21 (b) shows the quick
disconnect engaged and various components of the tank
and regulator. Regulator vent hole should be at 3, 6, or 9
o'clock. It should not be pointed up. Figure 21 (c).
(a)
Male
fitting
Hose
Regulator
Regulator
vent
Quick disconnect
engaged
(c)
Figure 21
Collar
(b)
Valve handwheel
close clockwise
Tank valve
Pressure
relief valve
Tank
Turn so regulator vent
does not collect water