Table of Contents
Advertisement
Quick Links
SUMMIT
BUILT-IN LP SIDE BURNER INSTALLATION/OWNER'S GUIDE
BUILT-IN LP SIDE BURNER INSTALLATION/OWNER'S GUIDE
YOU MUST READ THIS OWNERS GUIDE
BEFORE OPERATING YOUR GAS GRILL
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open fl ames.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fi re department.
Leaking gas may cause a fi re or explosion
which can cause serious bodily injury or
death, or damage to property.
WARNING
1. Do not store or use gasoline or other
fl ammable liquids or vapors in the vicinity
of this or any other appliance .
2. An LP cylinder not connected for use shall
not be stored in the vicinity of this or any
other appliance.
Summit
THESE ACCESSORIES MAY BE PURCHASED SEPARATELY.
DANGER
®
#
®
Built-In LP Side Burner
WARNING: Follow all leak-check procedures
carefully in this manual prior to barbecue
operation. Do this even if the barbecue was
dealer-assembled.
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
WARNING: Do not try to light this appliance
without reading the "Lighting Instructions"
section of this manual.
42376
42376 US 01/10/06
LP
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Weber Summit 42376
Summary of Contents for Weber Summit 42376
- Page 1 THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY. WARNING: Do not try to light this appliance without reading the “Lighting Instructions” section of this manual. 42376 42376 US 01/10/06...
- Page 2 Built-In side burner if there is a gas leak present. Do not use a fl ame to check for gas leaks. Combustible materials should never be within 24 inches (11 mm) of the top, bottom, back or sides of your Weber Built-In side burner.
-
Page 3: Warranty
STORAGE AND/OR NONUSE • The gas must be turned off at the liquid propane cylinder when the Weber gas barbecue is not in use. ®... - Page 4 LOCATING YOUR BUILT-IN SIDE BURNER When determining a suitable location for your Built-In Side Burner installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Sum- ®...
-
Page 5: Test Connections
BUILT-IN GAS LINE LOCATIONS GENERAL CONSTRUCTION DETAILS ® • Summit Built-In side burner unit should be on site before construction begins. All dimensions have a tolerance of plus or minus +/- 1 / 4 ” inch. • Provide access for a corrugated gas line depending on the location of the side burner in relation to your main gas supply and regulator position. -
Page 6: Gas Line Piping
TYPICAL BULK PROPANE GAS SUPPLY INSTALLATION We recommend that this installation be done by a LICENSED professional. General Specifi cations for Piping Note - Contact your local municipality for building codes regulating outdoor gas grill installations. In absence of Local Codes, you must conform to the latest edition of the National Fuel Gas Code ANSI Z223.1/ NFPA 54. - Page 7 TEST CONNECTIONS All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of the National Fuel Gas Code ANSI Z223.1/NFPA 54. DANGER Do not use an open fl ame to check for gas leaks. Be sure there are no sparks or open fl...
-
Page 8: Connect Gas Supply
The minimum size of the ventilation hole (s) should not be less than 1/4 inch. The remote LP cylinder enclosure should be constructed with non- combustible materials. The remote LP cylinder enclosure should isolate the LP cylinder from the burner compartment, so that it provides shielding from radiation, be a fl... -
Page 9: Fill Liquid Propane Cylinder
You will need: LP cylinder, a soap and water solution and a rag or brush to apply it. Turn the LP cylinder so the opening of the valve is either to the front, side or rear of the Weber fuel gauge. Loosen the cylinder lock wing nut. Swing the cylinder lock down. Tighten the wing nut. -
Page 10: Check For Gas Leaks
Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been fl ame-tested. As a safety precaution however, you should recheck all fi ttings for leaks before using your Weber Gas Barbe- cue. Shipping and handling may loosen or damage a gas fi tting. - Page 11 Check: “T” Connection-to-Hose connections. The hose-to-Regulator connection. WARNING: If there is a leak at connections (2,3, or 4), turn OFF the gas. DO NOT OPERATE THE GRILL. Contact Customer Service 1-800-446-1071. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.
-
Page 12: Lighting The Side Burner
This vent should be free of dirt, grease, bugs etc. • The LP cylinder and connections supplied with your Weber have been designed and tested to meet government, American Gas Association, and Underwriters Laboratories requirements. -
Page 13: Maintenance
If the Crossover ignition system still fails to light, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com REPLACE IGNITER BATTERIES Parts required: 1 AA alkaline battery per igniter. Unscrew igniter button from front of control panel. Remove igniter button and contact spring. -
Page 14: Side Burner Troubleshooting
SIDE BURNER TROUBLESHOOTING PROBLEM Side Burner does not light. Flame is low in HIGH position. Push button ignition does not work. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your region using the contact information sheet provided with your manual. - Page 15 ATTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country. Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-Stephen Products Co. replacement part(s) information.
- Page 16 ©2003 The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber, Kettle Silhouette , Genesis, Austria; Kettle Silhouette ® tion, Botswana; Weber, Canada; Smokey Joe, Genesis, China; Kettle Silhouette Smokey Joe, Weber, One-Touch, Germany;...
Need help?
Do you have a question about the Summit 42376 and is the answer not in the manual?
Questions and answers