CyberData 011153 Installation Quick Reference

Connecting Power (PoE)
to PoE Network
Connecting Power (optional power injector)
to Network
Ethernet
Optional Power Injuector
(CyberData P/N 010867A)
Device
Error Codes
Message Meaning Action
E01 Time error This would normally occur at manufacturing first Power On, or at subsequent Power On if the
battery was low or dead. If it occurs more frequently, contact CyberData support.
Note: If there is an Invalid Time Error, then you will see E 01 on the display for one second
and the time will be reset to 00:00.
E02 Low battery Replace the battery. See the Operations Guide for instructions.
Note: If the Clock Kit battery is low, then at power up, you will see E 02 on the display for one
second before displaying the time that is in memory.
Contacting CyberData
Corporate Headquarters Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
CyberData Corporation
Web: http://www.cyberdata.net/support/contactsupportvoip.php
3 Justin Court
RMA Dept: (831) 373-2601 ext. 136
Monterey, CA 93940, USA
Email: RMA@CyberData.net
RMA Status:
Phone: 831-373-2601
Fax: 831-373-4193
Warranty information is available at:
www.CyberData.net
Web: http://www.cyberdata.net/support/warranty/index.html
© 2017, CyberData Corporation, ALL RIGHTS RESERVED
http://www.cyberdata.net/support/rmastatus.html
930349F
The IP Endpoint Company
The documentation for this product is released in an English language version only. You can download PDF copies of
CyberData product documentation at:
http://www.cyberdata.net/voip/011153/
WARNING: Electrical Hazard: Hazardous voltages may be present. No user serviceable part inside. Refer to qualified service
personnel for connecting or servicing.
WARNING: This product should be installed by a licensed electrician according to all local electrical and building codes.
WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant.
WARNING: This enclosure is not rated for any AC voltages!
Wall Mount Adapter Parts
(1) Wall Mount Adapter
Install Jumper JP1 Prior to Installing the Clock Kit
Make sure that jumper JP1 is installed prior to installing the Clock Kit (see the picture on the right). Installing JP1 powers
the Real Time Clock from the battery. If you do not install JP1, the clock will lose it's time when the power is disconnected.
Jumper Functions:
Jumper
JP1
JP2
JP3
JP4
JP5
Quick Reference Quick Reference
Installation Quick Reference
Wall Mount Clock Kit
011153*, RAL 9002, Gray White, Standard
011154, RAL 9003, Signal White, Optional
*Replaces the 011023 number.
(1) Drywall Mounting Kit
(1) Template for Wall Mount
(4) Plastic Ribbed Anchors
Adapter and Screw Holes*
(4) #6 Sheet Metal Screws
(4) #6-32 x 0.25-inch
FlatHead, 100-degrees
Countersunk Machine Screw
(3) #8-32 x 0.5 inch Non-
Drive Button Head Machine
Screw
Function
Battery - Connect
Manufacturing - Open
Manufacturing - Open
Manufacturing - Open
Manufacturing - Open
930349F
*Note: The drywall
mounting kit will be
included in the ceiling
speaker kit.
(3) #8-32 KEP Nut
JP1
© 2017, CyberData Corporation, ALL RIGHTS RESERVED