Skytech 3301-FSCRF Installation And Operating Instructions Manual

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT
Note: This product is designed for use with an attended hearth appliance or fire feature. Adults must be present when the
Control System is operating. DO NOT program or thermostatically set this Control to operate a hearth appliance or fire
feature when Adults are not physically present. Furthermore, DO NOT leave the hearth appliance or fire feature burning
unattended; it may cause damage or serious injury. If an Adult is going to be away from the hearth appliance or fire
feature for any length of time, then the handheld/wall mount, receiver/control module and application should be in the
"OFF" position.
INTRODUCTION
This SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas
heating appliances. The system can be operated thermostatically or manually from the transmitter. The system operates on radio
frequencies (RF) within a 20-foot range using non-directional signals. The system operates one of 1,048,576 security codes that are
programmed into the transmitter at the factory; the remote receiver's code must be matched to that of the transmitter prior to initial use.
The transmitter operates on (2) AAA size 1.5DCV batteries. It is recommended that ALKALINE batteries always be used
for longer battery life and maximum operational performance. IMPORTANT: New or fully charged batteries are essential
for proper operation of the multi-function transmitter. Insert (2) AAA size 1.5DCV batteries into the battery compartment
on the back of the transmitter, positioning the (+) and (-) ends of the batteries as indicated on the casing. When the
batteries are inserted, the screen in figure 2 (with similar numbers) will display.
MODE
DOWN UP
COVER
CLOSED
Fig. 1 Transmitter Front and Back Views
Skytech: 3301-FSCRF
Model: 3301-FSCRF
INSTALLATION AND OPERATING INSTRUCTIONS
TO INSTALL OR OPERATE
TRANSMITTER
MODE
DOWN UP
TIMER
TIME
SET
COVER OPEN
Note: If a LOW battery icon appears on the screen,
BACK OF
check the position of the batteries.
CAUTION: Due to the sensitive temperature-monitoring
components in the transmitter, it may be necessary to
allow the transmitter to stabilize to room temperature
before accurate room temperatures are displayed on
the screen. If the transmitter is activated from a
severe cold condition, it can take up to fifteen minutes
for accurate temperature readings to appear.
+
-
-
+
REV. 8-21-20 Page 1