Code 11; Set Lengths For Code 11 - Wasp Duraline WLS 8400 ER Series Product Reference Manual

8-34
WLS 8400 Product Reference Guide

Code 11

Code 11

To enable or disable Code 11, scan the appropriate bar code below.
Enable Code 11
*
Disable Code 11

Set Lengths for Code 11

The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 11 may be set for any length,
one or two discrete lengths, or lengths within a specific range.
One Discrete Length - This option allows the scanner to decode only those Code 11
symbols containing a selected length. Lengths are selected from the numeric bar codes
beginning on page D-1 in Chapter D, Numeric Bar Codes. For example, to decode only
Code 11 symbols with 14 characters, scan Code 11 - One Discrete Length, then scan 1
followed by 4. In case of an error, or to change the selection, scan Cancel on page D-7.
Code 11 - One Discrete Length