KKT KOLBE FLAT User Manual page 41

Mounting the hood
wall plug
• Remove the metal grease filters and mark the mounting holes
from the rear inside of the hood body.
• Take off the hood again.
Drill four ø 8 mm holes in the wall at the marked points and insert
wall plugs in the holes.
• Hang the cooker hood on the wall bracket and fix it to the wall plugs
Chimney installation.
from the inside of the hood using the screws.
Place the upper chimney into lower chimney
--
• Fasten the exhaust hose to the outlet.
--
Attach the lower chimney bracket to the lower chimney
Mark and drill 2 holes to fix the lower chimney bracket with
--
2 wall plugs and 2 screws ST4x30mm
Upper chimney
Lowerchimney
• Slide the upper shaft part into the lower one, paying attention to the position of
the ventilation slots according to the use for exhaust or circulating air (See figure).
• Attach the shaft bracket to the lower / outer shaft part.
2x ST4 x 30mm
Upper / Inner
shaft part
Shaft bracket
Lower / Outer
shaft part
41