IBM 2274 User Manual page 69

Error code and description
1783
IDE Secondary Channel
Slave
Drive Error
1800
IRQ Setting Error
PnP ISA Card(s) Disabled
1801
Expansion ROM
Allocation Failed
Troubleshooting
Here's what to do...
1 Make sure the IDE signal cable is properly connected
to the drive and to the system board.
2 Make sure the drive power cable is properly
connected.
3 Enter the Setup Utility and make sure that the IDE
Secondary Channel Slave parameter setting is set to
Auto. For information on using the Setup Utility, see
"Starting the Setup Utility" on page 74.
4 If the error still shows after performing the above
steps, the IDE drive may be defective. For more
information on using the Setup Utility, see "Using the
Setup Utility" on page 73.
1 Enter the Setup Utility and set the Reset Resource
Assignments to Yes, then reboot the system.
2 If the error message reappears, determine which
onboard device is least necessary and disable it under
the Input/Output Ports menu in Setup.
For information on using the Setup Utility, see
"Starting the Setup Utility" on page 74.
1 Enter the Setup Utility and set the Reset Resource
Assignments to Yes, then reboot the system.
2 Change the I/O expansion ROM address.
For information on using the Setup Utility, see
"Starting the Setup Utility" on page 74.
If any of these problems continue after taking the actions
listed, run the diagnostics programs that came with your
computer. If you need service, see "HelpW are support and
services" on page 81.
Responding to error codes
65