Opening And First Assembly Of The Stroller; Carry-All Basket; How To Use The Safety Harness; Adjusting The Backrest - Chicco Goody Instructions For Use Manual

Hide thumbs Also See for Goody:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
bled by an adult.
• To avoid all strangulation hazards,
never give children objects with
cords or strings attached, or leave
them close to such objects.
• Never use the stroller on staircases
or escalators: you could suddenly
loose control of it.
• Always pay attention when going
up and down steps or pavements.
• If the stroller is left exposed to di-
rect sunlight for an extended pe-
riod of time, allow it to cool down
before placing your child inside.
Prolonged exposure to direct sun-
light may cause the colour of the
materials and fabric to fade.
• Prevent the stroller from coming
into contact with salt water. It may
cause rusting.
• Do not use the stroller on the
beach.
• When not in use, the stroller should
be kept out of reach of children.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance.Cleaning and mainte-
nance operations must be performed exclusively by an adult.
CLEANING
The seat of the stroller can be removed (please see the section
FITTING AND REMOVING THE STROLLER LINING).Clean the fabric
parts using a wet terry towel and neutral soap.Periodically wipe the
plastic parts clean with a soft damp cloth.To prevent the formation
of rust, always dry metal parts if they have come into contact with
water.
The washing symbols and relative meanings are indicated below:
Hand wash
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean

MAINTENANCE

If necessary, lubricate the moving parts with dry silicone lubricant.
Regularly check the condition of the wheels and clean off all dust
and sand. To avoid friction that may compromise the correct func-
tioning of the stroller, make sure all plastic parts that run along the
metal tubes are clean of dust, dirt and sand.
Keep the stroller in a dry place.
GENERAL INSTRUCTIONS

OPENING AND FIRST ASSEMBLY OF THE STROLLER

WARNING: When opening the stroller, make sure that your child or
other children are at a safe distance.
WARNING: Make sure that during these operations the moving
parts of the stroller will not come into contact with your child.
1. Take hold of the handle (Fig. 1) and pull the stroller upwards
(Fig. 1A) until the structure has opened completely (Fig. 1B).
WARNING: Before use, ensure that the stroller is locked in the open
position, checking that the mechanism is effectively locked.
2. Assemble the rear wheels inserting the pin of the wheel into the
appropriate hole located on the rear tube, until it locks in place
(Fig. 2). To remove them use the button located on each wheel
(Fig. 2A).
WARNING: Before use, ensure that the wheels have locked correct-
ly.
3. Install the bumper bar by inserting it into the appropriate slots
located on the joints of the stroller (Fig. 3). Should you need to
remove it, press the buttons on both sides (Fig. 3A).
WARNING: Never use the bumper bar to lift the stroller up with
your child sitting in it.

CARRY-ALL BASKET

The storage basket is already installed. Should you need to remove
it, follow the steps outlined below.
4. The storage basket is attached to the frame at several points. Un-
snap the 2 snap buttons located on the rear of the basket (Fig. 4);
remove the lateral straps on the rear legs of the stroller (Fig. 4A);
unsnap the snap buttons present under the seat (Fig. 4B); open
the velcro straps on the front under the footrest (Fig. 4C).
To reassemble the basket follow the same steps backwards.

HOW TO USE THE SAFETY HARNESS

This stroller has a five-point safety harness featuring two shoulder
straps, two adjustment holes, a waist strap and a crotch strap with
buckle.
5. WARNING: When carrying children up to 6 months of age, the
shoulder straps must be passed through the 2 adjuster slots
(Fig. 5) and the waist strap through the vertical slots (Fig. 5A).
The height of the shoulder straps can be adjusted by using the dif-
ferent slots found on the backrest.
6. After placing the child in the stroller, fasten the belts (Fig. 6) pass-
ing the two prongs (A) through the shoulder strap buckle (B) and
then through the crotch strap (C); adjust the height of the shoul-
der straps so that they correctly fit your child's shoulders (Fig. 6A).
Always make sure that the straps are fastened correctly.To unfasten
the strap, press and pull the side prongs.
WARNING: Children must wear the safety harness at all times. To
ensure your child's safety, it is necessary to always use the safety
harness.
To make sure that the belts are fastened properly to the anchor
points, after placing your child inside the stroller, pull the end parts
of the belts firmly.

ADJUSTING THE BACKREST

The backrest can be adjusted to 3 positions.
7. To lower the backrest, lift the adjusting handle located on the rear
of the backrest (Fig. 7). To raise the backrest, simply lift it to the
desired position.
WARNING: The child's weight can make these operations more
difficult.
REAR BRAKES
The rear wheels have linked brakes, which can be applied simulta-
neously on both rear wheels by using the support tube.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents