Troubleshooting - Zanussi ZDLN1512 User Manual

REMOVAL OF FOREIGN OBJECTS
Check the filters and the sump after each use of
the dishwasher. Foreign objects (e.g. pieces of
glass, plastic, bones or toothpicks, etc) decrease
the cleaning performance and can cause damage
to the drain pump.
1. Disassemble the filters system as instructed in
this chapter.

TROUBLESHOOTING

WARNING! Improper repair of the
appliance may pose a danger to the
safety of the user. Any repairs must be
performed by qualified personnel.
The majority of problems that can occur can
be solved without the need to contact an
Authorised Service Centre.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The indicator
mittently.
• Acoustic signal sounds 1 time intermit-
tently.
The appliance does not drain the water.
• The indicator
termittently.
• Acoustic signal sounds 2 times inter-
mittently.
16
flashes 1 time inter-
flashes 2 times in-
2. Remove any foreign objects by hand.
CAUTION! If unable to remove
the objects, contact an Authorised
Service Centre.
3. Reassemble the filters as instructed in this
chapter.
Refer to the below table for information on possible
problems.
With some problems, the dedicated indicator
flashes intermittently to indicate a malfunction and
the alarm code.
Possible cause and solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance recharges the resin inside the water
softener. The duration of the procedure is approxi-
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog-
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clog-
ged.
• Make sure that the drain hose has no kinks or
bends.