Table of Contents
Advertisement
Settings
Device
Setting
BPU4500
Image format settings
Video output connector
settings
HDCU2000/
Image format settings
2500
Video output connector
settings
Transfer rate settings
CA4000
Prompter output
connector settings
Extension Mode Connection
The unit can be used to form a video signal extension system
by connecting it to a video camera (F65
mounted CA4000, HDC4300, or HDC-P43
fiber cables.
The system can be synchronized because using the external
genlock function.
Intercom systems and multi-camera operation systems are not
supported.
An external power supply or power supplied from the CCU
connector of an HDCE-200 is also required for the camera,
since power is not supplied from the unit.
HD signals down-converted from 4K signals or generated
normal speed signals from HFR video can be output from the
SLOT3 and SLOT4 outputs.
1) Requires an external power supply when the F65 is used in an
extension connection.
2) Requires the SKC-4065 F65 Adaptor.
3) Requires BPU4500 software version 1.31 or later. Also requires an
HKCU-SM100 CCU Extension Adaptor and single-mode fiber
cable.
Menu/Page
CONFIGURATION/<SYSTEM
SETTINGS>
CONFIGURATION/<OUTPUT FORMAT>
Can also be set using the control panel.
SYSTEM OPERATION/
<MULTI FORMAT>
SYSTEM OPERATION/
<OUTPUT FORMAT>
Can also be set using the control panel.
CCU CONFIGURATION/
<PROMPT/TRUNK>
MAINTENANCE/<SDI-OUT>
MAINTENANCE/<PROMPTER2 OUT>
1) 2)
or PMW-F55 with
3)
) using optical
Item
SYSTEM
RESOLUTION 4096×2160
FORMAT
FREQUENCY
SLOT1 to
SLOT4
FREQUENCY HD
HD-SD
DELAY
SLOT1 to
SLOT6
TRANSMIT
SDI-MONI
OUT
OUTPUT
Set value
Displays value set on
CCU.
Video output format of
each slot
Frame frequency
Frame (1F)
Video output format of
each slot
AUTO, HIGH BIT RATE
HD-PROMPT
PROMPTER2
13
Connection and Setup
Advertisement
Table of Contents
