Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Instructions for the Installer
General instructions
• After removing the packaging material from the
appliance and its accessories, ensure that the appliance
is not damaged. If you suspect any damage, do not use
it and contact an authorised service person or qualified
technician immediately.
• Make sure that there are no flammable or combustible
materials in the close vicinity, such as curtains, oil, cloth
etc. which may catch fire.
• The worktop and furniture surrounding the appliance
must be made of materials resistant to temperatures
above 100°C.
• If a cooker hood or cupboard is to be installed above the
appliance, the safety distance between cooktop and any
cupboard/cooker hood should be as shown (Fig. 5.1).
Positioning the Hob
It is recommended that the hob be installed in a worktop
with a minimum thickness of 38 mm and depth of 600 mm.
The cut-out dimensions and the recommended minimum
clearances from the hob to nearby surfaces are shown in
(Fig. 5.1) and (Fig. 5.2).
NOTE: If installing the hob over a standard cabinet, you may
have to remove part of the cabinet panels to allow the unit to
fit correctly.
NOTE: Gap between the cut-out and back of the wall MUST
be 60 mm Fig. 5.4.
If installing a built-in oven directly under the hob, a minimum
thickness of 38 mm worktop is required and must have an
air gap of 5 mm between the oven and the bottom of the
hob (Fig. 5.2).
If no built-in oven is installed underneath, and If the worktop
surface used has less than a 38 mm is used a 5 mm air gap is
still required (Fig. 5.2).
There should be a minimum air gap of 5 mm under
n
the hob. Failure to maintain a suitable clearance may
impair the performance of the hob.
NOTE: If the built-in hob is being installed directly above
a built-in oven, an additional spacer (not supplied) may be
required to maintain a clearance of 5 mm between the
underside of the built-in hob and the top of the built-in oven
Fig. 5.3.
Any hob hood should be installed in accordance with the
hood manufacturer's instructions.
Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for
the additional height of the flue trim, which is fitted to the
cooker hob.
INSTALLATION
410 mm
56 mm
50 mm
560 mm
650 mm min
Airflow
Spacer
Front fascia
n
IMPORTANT
* To achieve a 10 mm gap clearance, a spacer may be
required when installing directly above a built-in oven.
16
520 mm
590 mm
482 mm
552 mm
490 mm
600 mm min
50 mm min
ArtNo 314-0007 Induction hob clearances (Side)
Oven
Fig. 5.1
650 mm
60 mm
Fig. 5.2
10 mm min
Fig. 5.3
Hob Worktop
5 mm
*
Advertisement
Table of Contents
