Gerber EDGE 2 Owner's Manual page 28

CHAPTER 5
24
Troubleshooting
Message
PAUSED
CHECK FOIL
CHECK VINYL
DATA ERROR n
(Where n is a number)
THERMISTOR ERROR
WARMING UP
WARMUP ERROR
Z AXIS HOME ERROR
HOST INIT ERROR
Required Action
This message appears when ONLINE is
pressed while the EDGE 2 is printing.
Press ONLINE again to resume printing.
Press RESET to return to OFFLINE status.
Make sure foil is correctly loaded and
press ONLINE.
Make sure vinyl is correctly loaded and
press ONLINE.
1 Check the cabling between the
computer and the EDGE 2.
2 Make sure the EDGE 2 checksum
setting is the same as the Gerber
software checksum setting (refer to
"Changing the checksum" on page 21).
3 Terminate all EDGE 2 jobs in Gerber
Spooler.
4 Press RESET. The EDGE 2 is offline.
5 Press ONLINE. The EDGE 2 is online.
6 Retry the job.
If the message continues, contact your
distributor or the Gerber Field Service
Department and tell them the data error
number.
Wait for printhead to cool down. When
printhead is sufficiently cool, the
message is displayed.
Wait for machine to warm up and printing
to start.
If warmup takes longer than 5 minutes,
this non-recoverable error message
appears. Press the Reset key and call the
Gerber Field Service Department.
Call the Gerber Field Service Department.
Call the Gerber Field Service Department.
Paused