Controlling From An Ir Remote Control - Neo Pro BORREGO Integrator Manual

Audio – Selecting the Audio button will begin the process of
switching Audio matrix only
Video – Selecting the Video button will begin the process of
switching both the component and composite matrix.
Once one of the three In/Audio/Video buttons have been pressed,
the Borrego matrix switch will light all the valid the inputs. The 0
button will also be lit. Selecting 0 as the input number will mute
whatever output is selected in the following steps.
After an input number has been selected, press the "Out" key.
And finally, after pressing "Out", press the Output number you
wish to route the signal to.
To recap, the front panel is always done as a four-button sequence
of (In/Audio/Video), (number), (Out), (number).
Some typical examples of this might be the following.
Example 1 – You would like to route the Cable box on Input 5 to
the main display on output 1. Press In, 5, Out, 1.
Example 2 – You wish to now route your audio from the CD
changer on input 3 to the main AV receiver on output 1, but
continue watching the cable box from example 1. Press Audio, 3,
Out, 1.

Controlling from an IR remote control

Shortcuts:
(Select),(#) – Changes all outputs
(Setup), (left and right arrows), (Select), (Exit) – Setup menu
(Video1), (#), (Out), (#) – Controls YPbPr matrix
(Video2), (#), (Out), (#) – Controls composite video matrix
(Audio1), (#), (Out), (#) – Controls digital audio matrix
8
Borrego Matrix Switch User's Guide (DOC42-00004-D_NeoPro-Borrego.doc)