Table of Contents
Advertisement
Setup Menu
The user setup menu is only accessible with an IR remote, not
from the front panel. The same settings can also be controlled from
the serial ports. Refer to the Serial Protocols document for more
information on the commands.
To start the setup menu, press "Setup" on the remote control.
Use the "Left" and "Right" buttons to navigate through the
different options.
Use the "Select" button to change any of the optional settings.
The menus are as follows:
Setup:Panel LEDs
This option will turn off all the front panel LED lights. The
matrix's behavior is otherwise unchanged. The default in ON
Setup:Disp Lamp
This option will set the display brightness to one of four levels.
The default is 100%
Setup:AC Pwr
This option control what the matrix will do when AC power is first
applied, or after a power outage. Selecting "ON" will force the unit
to turn on, and the previous switch state will be restored. Selecting
"Stby" (default) will cause the unit to enter standby mode.
Setup:Touchpanel
This option will disable the front panel buttons. The default in ON
10
Borrego Matrix Switch User's Guide (DOC42-00004-D_NeoPro-Borrego.doc)
Advertisement
Table of Contents
