Table of Contents
Advertisement
They can also be used for both signal type simultaneously, as long
as care is taken not to route a signal of one type to a output of a
different type.
The analog audio matrix is labeled "L" and "R".
Outputs
Having a true matrix switch allows you to treat each output as a
'zone'. For example, Output 1 can be the home theater zone, and
output 2 can be the master bedroom zone. In this case you would
run a set of component video cables plus audio cables to each
zone. The maximum length of cable to each zone will vary on the
quality of the cable used, but if high quality cable is used, the
Borrego can support zones 300 feet away.
RS-232 Serial
The serial port on the rear panel is labeled "RS-232". It is wired as
a "DCE" device, which means it should be connected to a normal
PCs RS-232 port with a straight through cable. Connection to most
control systems should be with a straight through type serial cable,
such as the cable provided with the Borrego.
For the command protocols, please refer to the manual entitled
"Integrator's Guide to Serial Protocols".
USB
If you plan to use the USB communication feature of the Borrego,
connect the USB cable to the PC's USB port (flat end), and the
other end (square end) to the Borrego matrix switch.
Optionally you may choose to connect this cable later when you
are prepared to install the driver CD-ROM. Connecting the cable
will activate MS Windows plug and play wizard. On disconnect
5
Borrego Matrix Switch User's Guide (DOC42-00004-D_NeoPro-Borrego.doc)
Advertisement
Table of Contents
