Westfalia 94 61 29 Instruction Manual page 25

1) Air Hammer
Retaining Spring
Trigger
Air inlet
1d
Hold the air hammer firmly with both hands and put the chisel tip up
against the workpiece you want to chip.
Press the trigger (1b) and slowly move the air hammer along the
workpiece. Do not push down the chisel against the workpiece. If you are
not satisfied with the result, check the chisel for wear.
First disconnect the air hammer from the air supply when exchanging the
chisels, when not using the unit, after finished working and when applying
maintenance work. Press the trigger in order to remove any remaining air
from the air hammer.
20