Arranging A Daisy Chain; Defining The Mode Of The Phone - Avaya B199 Manual

• Send information to the master device when you adjust the volume on it.
Note:
You cannot make calls between the Master and the Slave devices.
In a daisy chain, the Slave device follows the signal from the Master device to enter the sleep
mode or the active mode.
In a daisy chain, each phone is powered by its own PoE injector. The phone powers the Smart
Mics when these are connected. The power available from each port is around 5 W.

Arranging a daisy chain

About this task
Use this procedure to arrange a daisy chain of one master B199 phone and one or two slave
conference phones or expansion microphones.
Before you begin
If you arrange the daisy chain made of several conference phones, prepare the connection cables.
The cables in the Avaya Daisy Chain kit are 5 and 10 meters long. You can purchase the Avaya
Daisy Chain kit as an accessory.
The cable of the Avaya Smart Mic is 3 m long.
Procedure
1. Connect the cable to the audio expansion port on the phone.
There are 2 audio expansion ports on B199 Conference Phone.
2. Connect the other end of the cable to the audio expansion port of the other phone.
In case of expansion microphones, the other end of the cable is fixed in the device.

Defining the mode of the phone

About this task
Use this procedure to define the mode of your Avaya Conference Phone B199 in a daisy chain.
• To define the mode of your B199 on the phone, do the following:
1. Log in as the administrator.
2. In the Settings menu, tap Phone > Daisy Chain.
3. Select the required mode.
The options are:
- Master
- Slave
August 2020 Using Avaya Conference Phone B199
Comments on this document? infodev@avaya.com
Expansion of the phone coverage
53