Vaillant geoTHERM VWS Series Installation Instructions Manual page 55

Display shown
Holiday programming
for cpl. System
Periods
1 >06.01.08
2 14.01.08
Room Temp. setpoint
>Set starting day
Basic data
Date 21.04.08
Day of
Mo
week
Time 09:35
>Values can be set
Code layer
Code number:
> 0 0 0 0
Standard code:
1 0 0 0
>Adjust numeric character
Table 8.3 Parameters that can be set in the Operator level
(cont.)
Installation instructions geoTHERM VWS/VWW 0020057444_01
Description
It is possible to program two holiday periods by
6
specifying the dates for the controller and all
system components connected to it. In addition, you
can set the desired target room temperature for hol-
08.01.08
idays here, i.e.independently of the preset timer pro-
30.01.08
gram. After the holiday time has elapsed, the con-
12 °C
troller automatically goes back to the previously se-
lected operating mode. The holiday program can be
activated only in auto and eco operating mode.
Connected cylinder charging circuits or circulation
pump circuits are automatically switched to OFF op-
erating mode during the holiday time program.
In the Basic data menu, you can set the current
7
date, the day of the week and, if no DCF radio re-
ception is possible, the current time for the control-
ler.
These settings apply to all connected system compo-
nents.
To access the Code layer (Technician level), enter
8
the appropriate Code (standard code 1000) and
press the right hand dial .
To view set values without entering the code, you
must press the
rameters of the code level by turning
the dial but not change them.
Security function: Your code entry is reset again
15 minutes after your last change in the Code level
(actuation of one of the dials). To gain entry to the
Code level again after that, you will have to enter
the code once more.
dial once. You can then view all pa-
Controller 8
Factory setting
Period 1:
01.01.2003 –
01.01.2003
Period 2:
01.01.2003 –
01.01.2003
Room Temp. set-
point 15 °C
1000
55