Vaillant geoTHERM VWS Series Installation Instructions Manual page 61

Display shown
Menu A: Installation Assistant
Installation
Language selection
Language
>Select
Installation assistant
Hydraulic scheme
Heat pump type
Electroplan
Accept change
>Select
Table 8.4 Parameters that can be set in the Code level (cont.)
Installation instructions geoTHERM VWS/VWW 0020057444_01
Description
You will be guided through the Installation Assistant,
Menus A1 and A2, during the initial commissioning of
the heat pump.
The Installation Assistant appears automatically dur-
ing initial commissioning.
Language: Set the local language
A1
During the initial installation the controller always
>GB english
starts with this menu (Installation Assistant).
A2
The hydraulic and electro plans must be set by the
installer during initial commissioning.
3 The heat pump type has already been set at the fac-
tory and may not be changed!
5
1
Hydraulic plan:
Yes
1 = no buffer cylinder, no DHW cylinder
2 = with buffer cylinder, no DHW cylinder
3 = no buffer cylinder, with DHW cylinder
4 = with buffer cylinder, with DHW cylinder
See Figs. 6.8 to 6.11.
Note: Other hydraulic plans may only be set if the
VWZ NC 14/17 accessory is used. More detailed infor-
mation regarding this can be found in the installa-
tion manual for the VWZ NC 14/17 accessory.
Heat pump type:
Type
4
6
8
9
10
16
18
20
21
22
Electroplan:
1 = all on the high tariff (see Fig. 6.2).
2 = low tariff for the compressor (see Fig. 6.3).
3 = low tariff for the compressor and electric auxilia-
ry heating (see Fig. 6.4).
Accept change:Yes/No;
"Yes" means that all the set values will be saved.
Description
VWS 61/2
VWS 81/2
VWS 101/2
VWS 141/2
VWS 171/2
VWW 61/2
VWW 81/2
VWW 101/2
VWW 141/2
VWW 171/2
Controller 8
Factory setting
61