Table of Contents
Advertisement
Maintenance
Warning: All maintenance work on the
chainsaw apart from the work described in this
manual may only be carried out by authorised
after-sales service personnel.
Chain brake operational test
Test the chain brake periodically to ensure
proper function.
Perform a chain brake test prior to initial cutting,
following extensive cutting, and definitely
following any chain brake service.
29
Test chain brake as follows (Fig. 29):
1. Place saw on a clear, firm, flat surface.
2. Start engine.
3. Grasp the rear handle (A) with your right hand.
4. With your left hand, hold the front handle (B)
[not chain brake lever (C)] firmly.
5. Squeeze the throttle trigger to 1/3 throttle, then
immediately activate the chain brake lever (C).
Warning: Activate the chain brake slowly
and deliberately. Keep the chain from touching
anything; don't let the saw tip forward.
6. Chain should stop abruptly. When it does,
immediately release the throttle trigger.
Warning: If chain does not stop, turn engine
off and take your unit to the nearest Gardenline
Authorised Service Centre for service.
7. If chain brake functions properly, turn the
engine off and return the chain brake to the
DISENGAGED position.
18
Helpline No. UK 0151 649 1500 / IRE 189 094 6244
Air filter
Warning: Never operate saw without the air
filter. Dust and dirt will be drawn into engine and
damage it. Keep the air filter clean! The air filter
must be cleaned or replaced after every 20
hours of service.
30
31
Cleaning the air filter (Fig. 30/31)
1. Remove the top cover (A) by undoing the
cover fastening screw (B) on the cover. You
can then remove the cover (Fig. 31).
2. Lift out the air filter (C) (Fig. 31).
3. Clean air filter. Wash filter in clean, warm,
soapy water. Rinse in clear, cool water.
Air dry completely.
Note: It is advisable to have a supply of
spare filters.
Hide quick links:
Advertisement
Table of Contents
