Table of Contents
Advertisement
3B
2. Assembly and Parts List
Layout (Fig. 3B)
1. Chain bar
2. Saw chain
3. Chain tensioning screw
4. Stop claw
5. Chain brake lever/front hand guard
6. Front handle
7. Starter handle
8. Spark plug
(under the air filter cover)
9. Air filter cover
10. Stop switch
11. Safety lock
12. Oil tank cap
13. Fan housing
14. Fuel tank cap
15. Rear handle/bootstrap
16. Chain guard
17. Choke/(carburetor setting)
18. Bar fastening nut
19. Throttle lever
20. Chain catch
Installation
Important: Do not start the engine until the
saw is fully assembled.
Important: Wear protective gloves at all times
when handling the chain.
08
Helpline No. UK 0151 649 1500 / IRE 189 094 6244
Please note that the Chain brake lever/front
handle guard (Fig. 6.) is supplied separately
in the box.
Fit the chain bar
To ensure that the bar and the chain are
supplied with oil, USE ONLY THE ORIGINAL BAR.
The oiling hole (Fig. 4/Item A) must be kept clear
of dirt and any build-up of residue.
1. Make sure the Chain brake lever is pulled
back into the DISENGAGED position (Fig. 5/Fig 6).
2. Remove the two bar fastening nuts (B)
from the main unit (Fig 7).
3. Fit the open end of the chain bar over the
die bar pins (F) (Fig. 8).
4
Hide quick links:
Advertisement
Table of Contents
