Clients List; Address Reservation - TP-Link TD-W9970 User Manual

computers that request IP addresses and the DHCP server that assigns the addresses. Each
of the device's interfaces can be configured as a DHCP relay. If it is enabled, the DHCP
requests from local PCs will forward to the DHCP server runs on WAN side. To have this
function working properly, please run on router mode only, disable the DHCP server on the
LAN port, and make sure the routing table has the correct routing entry.
 Note:
1) To use the DHCP server function of the modem router, you must configure all computers on the
LAN as Obtain an IP Address automatically.
2) You have to disable NAT of the WAN connections, or the DHCP Relay may not take effect.
3) If you select Disabled, the DHCP function will not take effect.
Click Save to make the settings effective.

4.6.2 Clients List

Go to DHCP Server
the modem router in the screen as shown below.
Client Name: The name of the DHCP client

MAC Address: The MAC address of the DHCP client

IP Address: The IP address that the modem router has allocated to the DHCP client

Valid Time: The time of the DHCP client leased. After the dynamic IP address has expired, a

new dynamic IP address will be automatically assigned to the user.
To update this page and to show the current wireless devices, click Refresh.

4.6.3 Address Reservation

Go to DHCP Server
clients via the next screen. When you specify a reserved IP address for a PC on the LAN, that PC
will always receive the same IP address each time when it accesses the DHCP server. Reserved
IP addresses should be assigned to the servers that require permanent IP settings.
Clients List, you can view the information about the clients attached to
→
Address Reservation, you can view and add a reserved address for
→
48
TD-W9970 User Guide