Subaru Legacy 2012 User Manual page 236

Hands-free mode, press the ON hook
switch .
! Preparation for using the Hands-
free system
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
NOTE
. Up to 5 cell phones can be regis-
tered (for type B audio).
. Up to 6 cell phones (including Blue-
®
tooth audio devices) can be registered
(for type C audio).
. When the ignition switch is turned to
the "Acc" or "ON" position, the regis-
tered cell phone may be automatically
connected to the system.
! Registering by operating dial
"TUNE" dial:
Type B audio
Type C audio
Select the menus by operating the "TUNE"
dial.
Type B audio:
1. Press the OFF hook switch
2. Select "ENGLISH"/"FRANÇAIS" by
operating the "TUNE" dial.
– "WELCOME!" will then be dis-
played.
3. Press the "TUNE" dial or the talk
switch .
4. Select the "RECORD NAME" menu, or
press the talk switch .
5. Say the name to be registered.
6. Select the "CONFIRM" menu.
– After "CAR M_MEDIA" is displayed,
a pass key will be displayed.
7. Input the displayed pass key into the
cell phone while "PKY: ****" is displayed.
Type C audio:
1. Press the OFF hook switch
– If no cell phone is registered,
"Welcome!!" is shown on the screen.
In this case, perform the procedure
after step 4.
2. Select the "Setup" menu.
3. Select the "Phone Setup" menu.
4. Select the "Pair Phone" menu.
5. Select the "Record Name" menu.
6. Say the name to be registered.
7. Select the "Confirm pair phone?"
menu.
8. Select the "Phone Only" menu to
register only a cell phone, or select "Int.
.
Audio" menu to register internal audio in
addition to the cell phone.
9. After "Car Multi-Media" is displayed, a
pass key will be displayed.
10. Input the displayed pass key into the
cell phone while "Passkey: ****" is dis-
played.
! Registering by using voice com-
mand system (type C audio)
NOTE
If no cell phone is registered, when the
OFF hook switch
come!!" is shown on the screen. In this
case, perform the procedure after step
4.
.
1. Select a mode other than "BT Audio"
mode.
2. Press the talk switch
"Setup".
3. Press the talk switch
"Phone Setup".
4. Press the talk switch
Phone".
5. Press the talk switch
name to be registered.
5-53
Audio
is pressed, "Wel-
and say
and say
and say "Pair
and say the
– CONTINUED –