Warning And Indicator Lights; Seatbelt Warning Light And Chime - Subaru Legacy 2012 User Manual

Hide thumbs Also See for Legacy 2012:
Table of Contents

Advertisement

Warning and indicator lights

Several of the warning and indicator lights
illuminate momentarily and then go out
when the ignition switch is initially turned
to the "ON" position. This permits check-
ing the operation of the bulbs.
Apply the parking brake and turn the
ignition switch to the "ON" position. For
the system check, the following lights
illuminate and turn off after several sec-
onds or after the engine has started:
: Seatbelt warning light
(The seatbelt warning light turns off
only when the driver fastens the
seatbelt.)
: Front passenger's seatbelt warning
light
(The seatbelt warning light turns off
only when the front seat passenger
fastens the seatbelt.)
: SRS airbag system warning light
ON /
: Front passenger's frontal airbag
ON indicator light
/
: Front passenger's frontal airbag
OFF indicator light
: CHECK ENGINE warning light/Mal-
function indicator light
: Coolant temperature high warning light
: Charge warning light
: Oil pressure warning light
: Engine low oil level warning light
: Windshield washer fluid warning light
: AT OIL TEMP warning light
(AT and CVT models)
/
: ABS warning light
: Vehicle Dynamics Control warning
light/Vehicle Dynamics Control opera-
tion indicator light
: Vehicle Dynamics Control OFF indica-
tor light
/
: Brake system warning light
: Hill Holder indicator light
: All-Wheel Drive warning light (AT and
CVT models)
: Low tire pressure warning light
(U.S. spec. models)
: Low fuel warning light
: Door open indicator light
: Cruise control indicator light
: Cruise control set indicator light
Instruments and controls
: Select lever/gear position indicator
If any lights fail to illuminate, it indicates a
burned-out bulb or a malfunction of the
corresponding system.
Consult your authorized SUBARU dealer
for repair.
&
Seatbelt warning light
and chime
Your vehicle is equipped with a seatbelt
warning device at the driver's and front
passenger's seat, as required by current
safety standards.
With the ignition switch turned to the "ON"
position, this device reminds the driver
and front passenger to fasten their seat-
belts by the warning lights in the locations
indicated in the following illustration and a
chime.
– CONTINUED –
3-9

Advertisement

Table of Contents
loading

Table of Contents