Front Fog Light Switch (If Equipped); Wiper And Washer - Subaru Legacy 2012 User Manual

Hide thumbs Also See for Legacy 2012:
Table of Contents

Advertisement

3-30
Instruments and controls
Front fog light switch
(if equipped)
The front fog lights operate under the
following conditions.
. when the light switch is in the "
position
. when the light switch is in the "AUTO"
position and the headlights turn on auto-
matically
However, the front fog lights turn off when
the headlights are switched to high beam.
To turn on the front fog lights, turn the front
fog light switch on the turn signal lever
upward to the " " position. To turn off the
front fog lights, turn the switch back down
to the "OFF" position.
The indicator light located on the combi-
nation meter will illuminate when the front
fog lights are on.
"

Wiper and washer

WARNING
In freezing weather, do not use the
windshield washer until the wind-
shield is sufficiently warmed by the
defroster.
Otherwise the washer fluid can
freeze on the windshield, blocking
your view.
CAUTION
. Do not operate the washer con-
tinuously for more than 10 sec-
onds, or when the washer fluid
tank is empty. This may cause
overheating of the washer motor.
Check the washer fluid level
frequently, such as at fuel stops.
. Do not operate the wipers when
the windshield or rear window is
dry. This may scratch the glass,
damage the wiper blades and
cause the wiper motor to burn
out. Before operating the wiper
on a dry windshield or rear
window, always use the wind-
shield washer.

Advertisement

Table of Contents
loading

Table of Contents