Speedometer; Odometer; Double Trip Meter - Subaru Legacy 2012 User Manual

3-6
Instruments and controls
The display can be switched as shown in
the following illustration by pressing the
trip knob.
1 : " " or " " and " " or "
*
be displayed when the ignition switch is
in the "ON" position.
2
* : MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle's initial movement
setting of the meter/gauge needles
has been set for activation "
the time of shipment from the factory.
. It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the "ON" position. Change the setting
when the ignition switch is in the
"LOCK" or "Acc" position.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer
" cannot
This meter displays the odometer when
the ignition switch is in the "ON" position.
The odometer shows the total distance
that the vehicle has been driven.
" at
If you press the trip knob when the ignition
switch is in the "LOCK" or "Acc" position,
the odometer/trip meter will light up. If you
do not press the trip knob within 10
seconds of illumination of the odometer/
trip meter, the odometer/trip meter will turn
off.
Also, if you open and close the driver's
door within 10 seconds of illumination of
the odometer/trip meter, the odometer/trip
meter will turn off.
& Double trip meter
1) Trip knob
This meter displays the two trip meters
when the ignition switch is in the "ON"
position.
The trip meter shows the distance that the
vehicle has been driven since you last set
it to zero.
If you press the trip knob when the ignition
switch is in the "LOCK" or "Acc" position,
the odometer/trip meter will light up. It is