Yamaha PHAZER PZ50X Supplementary Service Manual page 71

CABLE ROUTING
PZ50/PZ50GT/PZ50RT/PZ50MT
1 To the coolant temperature sen-
sor
2 To the knock sensor
3 Route the fuel hose over the wire
harness and fuel tank breather
hose.
4 Wire harness
5 Radiator fan motor lead coupler
6 Bundle the slack in the wire har-
ness and fasten it with the plastic
band.
7 Right handlebar switch lead cou-
plers
8 Route the sub-wire harness over
the wire harness and fuel tank
breather hose.
9 Fasten the wire harness and fuel
tank breather hose to the frame
rear cross member with the plas-
tic band.
0 To the oil level switch
A Fasten the wire harness, parking
brake cable, and brake hose to
the frame rear cross member
with the plastic band.
B Main switch
C Fuel tank breather hose
D Throttle cable
E To the brake caliper
F To the tail/brake light
G Fuel pump lead
H Fuel hose
I Fasten the fuel pump lead at the
white tape to the fuel hose with
the plastic band.
J Fuel pump coupler
K Fuel pump
L To the multi-function meter
M Install the fuel tank breather hose
to the fuel tank with the hose
clamp. Be sure to connect the
hose end that does not have a
paint mark to the fuel tank.
CABLE ROUTING
65
SPEC