Audio Setup Menu; Navigation Setup Menu; Others Setup Menu - Clarion NZ502 Quick Start Manual & Installation Manual

Audio Setup Menu

This menu includes: Balance, Fader, Select EQ, Sub
Woofer Ctrl, Sub Woofer Phase, High Pass Filter, low
Pass Filter, Amp Cancel and Magna Bass EX.
Balance: Choose the desired volume for left and right
speaker.
Fader: Choose the desired volume for front and rear
speaker.
Select EQ: Choose the desired mode: Bass Boost,
Impact, Excite, Custom and OFF.
Sub Woofer Ctrl: Choose the desired sub woofer gain
from 0 to 14.
Sub Woofer Phase: Choose the sub woofer phase
normal or reverse.
High Pass Filter: Choose the high pass filter
through/55Hz/85Hz/120Hz.
Low Pass Filter: Choose the low pass filter
through/62Hz/95Hz/135Hz.
Amp Cancel: Choose the amplifier audio output on
or off.
Magna Bass EX: Choose the loudness on or off.

Navigation Setup Menu

This menu includes: GPS Time, Navi Interrupt, and
Voice Guidance
GPS Time: Set the system time to be synchronized
with GPS local time or not.
Navi Interrupt: There are three choose: On/Popup/
Off. "On": The navigation screen will cover to AV
screen when reaching some key point. "Popup": When
28 NZ502
small turn info window will pop up in the top of the
AV screen to indicate the key point. "Off": Turn off this
function.
Voice Guidance: Enable or disable the navigation
voice guidance.
Voice Guidance Mix: There are two choose: On/Off.
"On": The navigation voice guidance will play at the
same time and the voice of the current source. "Off":
Only the navigation voice guidance. (Voice Guidance
On )

Others Setup Menu

Set password: Set the password for DVD parental
control.
Parental control: Set the rating of the age. It contains
Kid Safe/G/PG/PG- 13/PG-R/R/NC- 17/Adult.
Audio Language: Set the Language for DVD Audio.
Subtitle Language: Set the Language for DVD subtitle.
System Language: Set the Language for system
screen.
Blinking LED: Select the blinking LED On/Off.
Screen Calibrate: The function of it is to select the TS
Calibrate YES or NO.
Factory Default: The function is to select to load
factory default or not.