Table of Contents
Advertisement
CDMA 800/1900
supply and an MCEL 2000 test cable or test
plug. After powering up in test mode, press
the # button to enter Servicing Level. Once
in Test Mode Servicing Level, enter 55# to
place the phone in NAM programming
mode. The display will show factory default
NAM data or show new data as it is entered,
scrolling from left to right. Sequentially step
through the procedures shown in Table 4:
"Test Mode NAM Programming Sequence"
on page 26 using the * key. Enter new data
as required, or skip past factory default
values for parameters that do not need to be
changed.
If a second phone number is to be
programmed, step 11 bit 6 must be set to 1.
This bit enables dual-NAM operation and
will cause NAM programming steps 1-6 and
12 to be repeated for the second phone
number.
Minimum Required Test Mode
Factory
Step
Default
01
00000
02
00000100
0
52
NAM Programming Steps
Service Type
Single NAM
Dual NAM (part A)
Dual NAM (part B)
Test Mode NAM Programming Sequence
step; also programs the NAMafter the last
programming step is entered. A valid value
must be entered. Otherwise the phone will
not advance to the next NAM step.
displays previously entered data for the cur-
rent programming step.
programming the NAM.
Test Mode NAM Programming Sequence
Table 11:
CLR=
Home System ID (SID) Number. Number assigned by system operator
for system identification.
A OPTION BYTE. The display for step 02 represents the status of eight
options, A7 through A0. Bit A7 (msb) is programmed first, followed by A6-
A0. Bits enter display on the right and scroll left.
Local Use (Bit A7). If set to 1 phone will respond to local control orders in
the home area or when the group ID is matched. Assigned by system
operator.
Table 10:
Minimum Required
Programming
Steps
1, 3, 4, 6, 8, 9
1, 3, 4, 6, 8, 9, 11
1, 3, 4, 6
Advances to the next programming
Clears the entered information and
Exits the programming mode without
*
Description
#
4/3/01
Advertisement
Table of Contents
