JUKI HZL-NX7 Service Manual page 10

9) Front panel

F
○ Remove setscrews  to  from the front panel.
○ Put a thin screwdriver in the notch A in the rising section under the arm and
pry off the front panel and hook B of the rear panel. (Fig 1)
○ Detach clinch nails ( C and D) of the front panel and rear panel, while pushing
down the front panel.
○ Opening the right side of the front panel in the direction of the arrow, tap E
section with your hand to remove hook F located at the bed surface.
○ Lastly, remove hook G located at the lower side of the machine jaw.
○ If needed, remove the switch/slide VR connector (CN17) and panel I/F con-
nector (CN19) from the main PCB. Then, remove the LED1 connector (CN208).

A
B
E


Fig.1
– 8 –

C
D
G