Basic Operation; Making Calls; Volume Control; Channel Changing - VTech 9126 Operation Manual

BASIC OPERATION

VOLUME CONTROL

While you are on a call, press
will display the relative volume setting as you adjust it.

CHANNEL CHANGING

If you experience noise or interference while on a call, you may be too
far from the Base Unit, or in an obstructed area. Try moving to a
different location. If this does not improve the transmission, press
PROG/CHAN. You can press this key more than once, if necessary.
NOTE: This feature only operates while you are on an active call.

MAKING CALLS

Method 1------Live Dialing
Press PHONE. Dial the phone number.
Press OFF to end your call.
Method 2------Pre-dialing
Dial the phone number. Use the
if you make a dialing mistake. Then press PHONE.
Press OFF to end your call.
When the handset is in use, the IN USE/CHARGE light
on the Base Unit will flash. When the Handset is in the
Base Unit cradle, the IN USE/CHARGE light glows
steadily.
to raise the inbound volume and
10
key to backspace
to lower it. The handset