Saxby Lighting SightEco 72640 Instruction Leaflet

Emergency wall light

Download this manual

Cleaning Information

• We recommend cleaning with a soft dry cloth or wash

with warm water or just use a damp cloth.

Recycling advice

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.

Check with your Local Authority or retailer for recycling advice.

Safety information

Live Voltages may be present in this unit even when turned of or when completely disconnected.

For your safety, always switch off the supply before changing lightbulbs, or cleaning.

This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.

This bulb is protected by a shade. This part must be replaced immediately should the shade become

cracked or damaged. This fitting must not be used without the shade in place.

www.saxbylighting.com

• Do not use abrasive materials as these will damage the

finish.

Iss 1 20102017

Saxby Lighting. BH23 3PE

Instruction leaflet

SightEco Emergency Wall Light

72640

Need help?

Do you have a question about the SightEco 72640 and is the answer not in the manual?

Page 1 This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped. This bulb is protected by a shade. This part must be replaced immediately should the shade become cracked or damaged. This fitting must not be used without the shade in place. Iss 1 20102017 www.saxbylighting.com Saxby Lighting. BH23 3PE...
Page 2 Installation Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Existing fittings must be completely removed before • Using the unit as a template, mark the position of installation of a new product.
Page 3 Operation in Maintained mode Battery Replacement • The light will remain lit all the time and in the event • Charge the battery for at least 24 hours before first use. • If after routine operation check, the lamp does not remain • Replace the battery with a 3.6V 600mAh Ni-Cd of a power failure will remain on. The unit will charge lit for the three hour period, a new battery pack may be ONLY. Use of a different type of battery will damage the • If the LED is not illuminated then there may be no a.c.