Saxby Lighting 1818S Instruction Leaflet

Commissioning
• Refit the plastic cover over the terminal block and secure
in place using the screw.
• Refit the front section in place, and refit the screw at the
bottom.
Fitting/replacing bulbs
• When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Dispose of
used bulbs carefully. Do not exceed the wattage stated
or use a different shape bulb from that indicated on the
fitting.
• Do not exceed the wattage stated or use a different shape
bulb from that indicated on the fitting.
• Unscrew the bulb anti clockwise to remove.
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by a glass shade. This part must be replaced immediately should the glass
shade become cracked or damaged. This fitting must not be used without the glass shade in place.
www.saxbylighting.com
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
• Carefully locate the bulb in the lampholder and turn
clockwise to secure.
Glass parts – Wash with warm water or just use a damp
cloth. Do not use abrasive materials as these will damage
the finish.
Iss.2 21072015
Saxby Lighting Ltd. LS9 0SE
Instruction leaflet
Traditional Half-Lantern Wall
1818S