Table of Contents
Advertisement
[12]
[10]
[4] [5]
[11]
When mounting the pulley cover, be sure to mach the claw [A] against
the hole in the front side plate of the compartment.
3.4.4.2 Routing the Lifter Cable
1) Check to be sure that the lifter driver shaft [1] and the lifter [2] are fixed
in place by the 2 hex screwdrivers [4] and a hex wrench [3] or the like.
2) Secure the 4 cable fixing plates [5] in place to the lifter using 2 screws
each.
3) Hook the lifter cable [6] on the 4 pulleys [7].
4) Hook the ball of the lifter cable on the 2 pulleys found at the front/rear of
the lifter drive shaft; then, wind the cable about 1.5 times along the groove
of the pulley.
At this time, see to it that the lifter cable is taut just enough to lift the long
screwdrivers used to keep the lifter in place.
5) Secure the 2 pulleys [5] in place to the lifer drive shaft using a set screw
[9] (1 each).
6) After mounting all pulleys you have removed to the lifter drive shaft,
measure the height A from the base plate of the compartment to the top
surface of the lifter at several points, thereby making sure that the lifter is
level.
[6]
[9]
[8] [7]
[3]
[2]
F-3-23
[A]
F-3-24
[6]
[A]
[5]
[8]
3.4.5 Lifter Cable
3.4.5.1 Removing the Lifter Cable (deck rear)
1) Open the compartment.
2) If there is any paper, remove all of it.
3) Remove the screw [1], and detach the upper sensor cover [2] and the lower
sensor cover [3].
4) Disconnect the 4 connectors [4].
[4]
0023-7288
There are 2 claws on the top of the sensor cover; be sure to take care not
to break them when removing the cover.
5) Remove the 5 screws [3], and detach the plate [4].
[3]
6) Insert a hex wrench [2] or the like into the hole of the lifter drive shaft [1]
to keep it from turning.
If you fail to perform this step, the lifter cable will become slack as soon
as you remove the lifter motor unit.
[5]
[7]
[1]
[7]
[A]
[A]
[9]
[3]
[5]
F-3-25
[4]
[2]
[3]
[4]
F-3-26
[4]
F-3-27
Chapter 3
[8]
[9]
[5]
[A]
[4]
0023-7293
[1]
[3]
[1]
[2]
[3]
3-5
Advertisement
Table of Contents
