Table of Contents
Advertisement
Chapter 4
4.2 Adjustment
4.2.1 Basic Adjustment
4.2.1.1 Checking the Image Rear/Front Position for
Pickup from the Side Paper Deck
Make a 100% copy, and check to make sure that the margin on the front of
the image is 2.0 -/+1.0 mm; if not, adjust the registration.
(-)
(+)
2.0±1.5mm
0
2
4
6
8
10
4.2.1.2 Adjusting the Rear/Front Registration for the Side
Paper Deck
1) Push the deck releasing grip [1] to detach the deck from the host machine;
then, push down the latch plate [2] found at the left rear with a finger to
open the compartment.
2) Adjust the latch plate [1] of the deck open solenoid (SL2) found at the left
rear using the 2 screws [2].
(-)
(+)
2.0±1.5mm
0
2
4
6
8
10
At this time, use the indexes on the latch plate as a reference.
3) Close the compartment, and check to make sure that the gap of the front
cover is 3 -/+1 mm.
4) If not 3 -/+1 mm, adjust the front cover.
4.2.1.3 Adjusting the Pressure of the Deck Separation
Roller
If pickup faults or double feeding occurs when the deck is used as the source
4-2
F-4-1
F-4-2
F-4-3
of paper, relocate the pressure spring [2] of the deck separation roller [1]:
- if pickup faults occur, move the spring in the direction of arrow A.
- if double-feeding occurs, move the spring in the direction of arrow B.
0023-7352
4.2.1.4 Adjusting the Position of the Spacer
If the compartment cannot be opened/closed smoothly and, thus, requires ad-
justment of the spacer mounted to the front of the deck, go through the fol-
0023-7353
lowing:
1) Push the deck releasing grip [1] to detach the deck from the host machine;
then, push down the latch plate [2] found at the left rear with a finger to
open the compartment.
2) Loosen the 4 screws [1], and detach the front cover [2] toward the front.
Do not remove these screws.
1. When attaching the front cover, be sure that the coupling [1] used to indi-
cate the paper level is correctly matched.
0023-7354
[1]
A
B
[2]
F-4-4
F-4-5
[1]
[2]
F-4-6
0023-7355
Advertisement
Table of Contents
