Replacing Bulbs; Checking And Replacing Blade - Kubota GR1600-II Operator's Manual

C Protected circuit
FUSE NO. CAPACITY
(ID LABEL) (A)
E/G STOP 15
(1) IG/M 10
--- 3
Slow blow fuse
(2) ---
40
BReplacing bulbs
(A) Replacement of the headlight bulb
1. Open hood.
2. Turn bulb socket to remove socket from headlight
housing.
3. Push bulb down and turn one quarter turn to remove
bulb from the socket.
4. Install new bulb to the socket.
5. Install the socket in housing.
6. Close hood.
Headlight bulb
(B) Replacement of the Indicator light bulb
1. Open hood.
2. Turn bad bulb socket to the left.
And remove it.
3. Pull bulb from the socket.
4. Push new bulb into the socket.
5. Install the socket.
6. Close hood.
Indicator light bulb
Protected circuit
Engine stop timer relay
Fuel pump, Head light
Power steering control
unit, etc.
OPC
Check circuit against
wrong battery connection
24W
14.0 Rated Voltage/0.27
AMP/2 MSCP
PERIODIC SERVICE
BChecking and Replacing Blade
To avoid personal injury:
A Be sure to stop the engine and remove the key.
A Blades may be sharp. When you handle blades,
wear heavy gloves or wrap end of blade with a
rag.
C Checking
The blade cutting edges should be kept sharp at all times.
Sharpen the cutting edges, if they resemble blade (B).
Replace the blades if they appear similar to blade (C).
67
(A) New blade
(B) Worn blade
(C) Cracked blade