Headlight Beam Adjustment - Yamaha FX10X Assembly Manual

b b a a
1

HEADLIGHT BEAM ADJUSTMENT

1. Place the snowmobile on a level surface.
2. Place the snowmobile from the wall at a dis-
tance D indicated by the chart below.
3. Measure the distance from the floor to the cen-
ter of the headlight H and place a mark on the
wall equal to height H from the floor.
4. With a person sitting on the snowmobile, apply
the parking brake, start the engine and let it idle.
5. Turn the headlight to high beam and check the
headlight projection height on the wall. The pro-
jection should be at the parallel mark on the wall
H to 1/2° down S from the mark. If not, adjust
the headlight angle.
D 3.0 m (10 ft)
S 26 mm (1.0 in)
D: Distance H: Height
6. Adjust:
• Headlight beam (Vertically)
Adjustment steps:
• Remove the shroud.
• Turn the adjusting screw 1 in or out to adjust
the headlight beams.
Direction a
Direction b
3-16
7.6 m (25 ft)
66 mm (2.6 in)
S: Set range
Headlight beam is raised.
Headlight beam is lowered.