HEADLIGHT BEAM ADJUSTMENT
ELECTRICAL
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine in front of a wall at the
recommended distance D. Refer to the table
below.
3. Measure the distance H from the floor to the
SEJ2710
center of the headlight and place a mark on
the wall at that height.
4. With a person sitting on the machine, apply
the parking brake, start the engine and let it
idle.
5. Switch on the headlight's high beam and
check the height of the projected beam on the
wall. The projection should be at the position
marked in step 3 or 1/2° lower (distance S).
D
S
D: Distance
6. Adjust:
•
SEJ2720
7. Adjust:
•
2-31
INSP
ADJ
3.0 m (10 ft.)
26 mm (1.0 in.)
S: Set range
Headlight beam (vertically)
Vertical adjustment
Higher
Turn the adjusting screw 1 + 2
clockwise.
Turn the adjusting screw 1 + 2
Lower
counter clockwise.
Headlight beam (horizontally)
Horizontal adjustment
To right Turn the adjusting screw 1
clockwise or turn the adjusting
screw 2 counter clockwise.
Turn the adjusting screw 2
To left
clockwise or turn the adjusting
screw 1 counter clockwise.
7.6 m (25 ft.)
66 mm (2.6 in.)